Hello all,
We are using NCM product and inventory report to perform our capacity planning.
But we are able to see some discrepencies between the NCM database and what is really in place.
For example, we removed a card module from a Cisco 6513, but we still see interfaces from this module into the Inventory report.
The problem is that this module has been removed from the switch with reseting flash, so directly connected to the switch, if we perfom the "show interface summary" command, we still see the interfaces which were attached to the removed module. But if we perform a "show module" command, the module is not there.
Into the NCM database, we still see old interfaces.... How can we remove them? Will they come again into the database on the next inventory?
Many thanks for your help.
Eric.