Seeking method for NCM to import large numbers of addresses, FQDN's, or...
I was given a spreadsheet with several thousand IP addresses (hosts), networks (/23, /24, /25, /26, /29, etc.), ranges (x.x.x.x - x.x.y.y) and FQDN's that need to be built as Network Objects in a Cisco...
View ArticleClik here to view.
Need help with NCM Password Change Script/Template
Hi All, I am trying to update the credentials of an emergency username and password for all of my IOS devices. I have 2 problems currently: 1.) NCM logs into my test device and starts to execute the...
View ArticleNCM script to append description based on trunk mode
First, I am not apposed to using a compliance report or a config change template or a combination of the two. Right now I have a compliance report that will check each interface for Mode Trunk, if that...
View ArticleArithmetic Operations with Configuration Change Templates
Hi Twack Community, I'm looking for a solution to do aritmetic operations inside a Configuration Change Template. Currently I'm struggeling to get following informations script calculation(...
View ArticleSearching for Syslog Message Pattern
I have all the devices sending the commands logged on to any device to NCM and it sends me an Email notification for every command entered. However, when I log in to ASDM, I get 35 Emails, and I am...
View ArticleClik here to view.
Rules with multiple steps
Hello everyone, I'm new to NCM and this is my first question on the forums. I have been tasked to move the compliance checking from our current tool (NCM smarts) to SolarWinds NCM and I'm trying to...
View Article2 variables in config change template for juniper MX
Hello Guys, I have created a config change template to automate creation of VRFs on my juniper MX @INTERFACE_IP_ADD.@VLAN_ID Above are 2 variables seperated by a dot. For example , lets say my...
View ArticleClik here to view.
SolarWinds NCM Connector for Cisco SmartAdvisor
Saw this came out and took a look at the documentation. Is there a special kind/level of Cisco account/access you need for this to work? I have a Cisco.com account that is linked to my contracts (lets...
View ArticleNCM Criteria Comparison - Leading Characters
Working with a set of Dell 6248 switches. The config comparison in NCM shows all lines different because of leading characters. How would ignore these leading characters? Startup on Left has a number...
View ArticleHow to Add Custom Properties to NCM Reports NCM 7.5/NPM 12.0
I have customized inventory reports that add custom properties to the report to help with sorting and only pulling inventories for specific sties. Now that the NCM reports are now on All Reports web...
View ArticleAnyone know how the Native Poller for CPU & Memory is Configured?
Anyone know how the Native Poller for CPU & Memory is Configured? Specifically, the memory configuration and the OIDs they use?
View ArticleConfigurations not being backed up
Ever since I upgraded to NCM 7.5, I noticed 8% of my devices are not backed up. I have to manually go in and do a backup on them, then they back up normally. I have 91 nodes, that I now have to go...
View ArticleIterate through Router Interfaces and Conditionally Add a Config Statement
Folks, What I'm doing to achieve is for the script to detect that there is a Loopback1 on a Cisco router interface and give it a description. This is what I have so far: /*.CHANGE_TEMPLATE_DESCRIPTION...
View ArticleJunos Routing Instance
Hi I'm trying to get NCM to deploy new routing instances to some Juniper kit. I've managed to get a script together that seems to output what looks like readable config however when it tried to...
View ArticleCisco Switch Stack IOS Upgrade Question...
Just curious if anyone else has seen this before.. I tried to use NCM to roll out a IOS upgrade to several Cisco 2960-S switch Stacks. I chose to use the following command archive download-sw...
View Article