Cisco 5508 WLC Backup - IOS 7.4.*.*
I have created the following command script which has assisted me with downloading configs for the Cisco 5508 WLC running IOS Version 7.4.*.*This has worked fine on both TFTP and SFTP. To download...
View Article"Test Failed. Unable to Log into Router : Timeout" False Alarm
I have recently noticed that NCM was having issues downloading configs. I also had to add a switch that was not listed, but when I did the test it comes back "Test Failed. Unable to Log into Router :...
View ArticleUnable to remove node from NCM
I have a node in NCM that I cannot delete. If I delete it in NPM it does not delete it in NCM. If I do a database sync, it reappears in NPM. If I then try again to delete it, it removes it from NPM,...
View ArticleClik here to view.
Can't see any interfaces in NCM managed devices
Hello Community, i have a little (big) problem with the NCM.We are using Cisco 2960S Switches, we are polling over ICMP and SNMPv3 and it works. But when i want to list resources there are no...
View ArticleClik here to view.
Switching to polling engine NCM 7.2.2 job execution.
I am looking into moving our NCM jobs out to each of our polling engines and don't see how I would setup a job to target just devices on a particular engine. The built in help states the following......
View ArticleConnection refused during Cisco config download
I am using NCM7.2.2 to download a cisco switch config from the web console. When I go try to download it, I get the message that the connection was refused the by the switch IP address. I have tried...
View ArticleQuestion about install steps from NCM Admin Guide
We just recently ran an NPM upgrade to 10.6.1. Long story short, is we had some issues and ended up uninstalling the NCM integration (7.0.2) piece on the NPM server, but did not touch the NCM install...
View ArticleWhere does the NCM store the config change templates ?
Hello Community, i have a simple question, where does SolarWinds NCM store the configuration change templates, is it stored in the database or in a special path on the Server ? Thanks in advanceAmir
View ArticleCan't find custom property I added in drop down list to allow me to "group...
I created a custom property which I planned to populate with a value which would distinguish it and allow me to choose this particular node to run my config change template on. However when I go to...
View ArticleClik here to view.
What is your preference for the NCM database migration process?
As you may know from the What We Are Working On For NCM After 7.2 post, NCM and NPM/Core databases are going to be merged.One part of the merger is data migration from NCM database to NPM...
View ArticlePoll Dell Service Tag
Has anyone found a way to poll Dell service tag numbers from Dell switches? NCM polls a serial number, but I haven't been able to find anything in the inventory reports for the service tag. Also, when...
View Article