Hi,
I have an issue with our Nexus 7000 and connect by ssh v2.
I try to connect direct to my vdc and Login in. The Login works fine, but after the ncm logs in it sends an "enable" command. The response is "%invalid command at '^' marker. It Points to the send "enable" command.
I get a # at Login . I dont have to send a "enable" command.
Sure I have disabled the "Enable Level" to "no Enable Login" .
How can I remove this enable in this template?
The problem is that I could not download any config or do some configuration over ssh with this error.
Thx a lot for response
otto